BMW 2004 330xi Sedan Manual Do Proprietário

134

Coolant

Do not add coolant to the cooling
system when the engine is hot. If

you attempt to do so, escaping coolant
can cause burns.
Antifreeze and anti-corrosion agents
are hazardous to health. You should
always store them in closed original
containers and in a location which is
out of reach of children. Antifreeze and
anti-corrosion agents are inflammable.
For this reason, do not spill them on hot
engine parts. They could ignite and
cause serious burns. Comply with the
instructions on the containers.

Comply with the applicable envi-
ronmental laws regulating the dis-

posal of antifreeze agents with corro-
sion inhibitor.

Checking the coolant level and
adding coolant

Check the coolant level when the
engine is cold, approx. 68

7/+206.

1. Open the cap for the expansion tank

by turning it slightly counterclock-
wise to allow accumulated pressure
to escape, then open

2. The coolant level is correct when the

upper end of the red float is at least
even with the upper edge of the filler
neck; see arrow. The end of the float
may stick out by a maximum of
3/4 in / 2 cm – that is, up to the sec-
ond mark on the float

3. If necessary, add coolant. If the cool-

ant is low, slowly add coolant until
the correct level is reached – do not
overfill.

Brake fluid

Indicator lamp

The brake warning lamp comes
on when the parking brake is
not engaged: the brake fluid

level is too low, refer to page

Brake warning lamp for Cana-
dian models.

Adding brake fluid

For adding brake fluid or for determin-
ing and correcting the cause of brake
fluid loss, consult your BMW center.
Your BMW center is familiar with the
specifications for factory-approved
brake fluids – DOT 4.

Brake fluid loss results in extended
pedal travel. Refer to the information on
page

122