Lenovo L1210E Folheto

Allow the projector to cool for at least 60 minutes.

Turn off the projector and unplug the power cord.

Gently press the lamp into place.  Then tighten 
the screw.

Gently press the yellow tab inward until it stops. 
You can feel the lamp connector engage.

Slide the front grill toward the lens until it snaps into 
place. To reset the lamp timer, press and hold the 
reset button, then press the menu/select  button 
(while still pressing the reset button) for 10 seconds.

9

*009-0563-04*

Place the projector rightside up on a flat
surface. Pull the yellow tab on the lamp outward.
 This disengages the lamp connector.

Place the projector on its side. Slide the lamp into 
the projector. Make sure that the bottom of the lamp 
fits into the rails inside the projector (circled above).

Loosen the captive screw on the lamp.

Place the projector on its side. Grasp the pull tab to 

pull the lamp out. Dispose of the lamp module in 
an environmentally proper manner.

Place the projector on its rear. Insert a small screw-driver 

into the slot near the front. Slide the latch downward. Hold 
the latch open while you slide the lamp grill off.

Pull tab out     

The projector

must be

as shown.

Slide and hold latch

Slide lamp grill off