Woodstock M1109 Manual Do Utilizador

-11-

M1109 Combo Lathe/Mill

• Floor Load: Your lathe/mill is a heavy load (1200

lbs.) distributed in a 61

" x 27

" footprint. Place

this machine on concrete floors only. The floor

MUST be level, or the lathe/mill frame and ways

may distort over time.

• Working Clearances: Consider existing and

anticipated needs, service panel access, length of

rods to be loaded into the lathe/mill, and space for

auxiliary stands, work tables or other machinery

when establishing a location for your lathe/mill

(see

Figure 9 for minimum wall clearances).

• Lighting: Lighting should be bright enough to

eliminate shadow and prevent eye strain.

• Electrical: Outlets must be located near each

machine, so power cords are clear of high-traffic

areas. Follow local electrical codes for proper

installation.

Cleaning Machine

The ways and other unpainted parts of your lathe/mill

are coated with a waxy grease that protects them from

corrosion during shipment. Clean this grease off with a

solvent cleaner or citrus-based degreaser. DO NOT use

chlorine-based solvents such as brake parts cleaner, lac-

quer thinner, or acetone—if you happen to splash some

onto a painted surface, you will ruin the finish.

Machine Placement

ALWAYS work in well-

ventilated areas far from

possible ignition sources

when using solvents to clean

machinery. Many solvents

are toxic when inhaled or

ingested. Use care when

disposing of waste rags

and towels to be sure

they DO NOT create fire

or environmental hazards.

NEVER use gasoline or

petroleum-based solvents

to clean your lathe/mill.

��

��

��

��

Figure 9. Minimum wall clearances.

MAKE your shop “child safe.”

Ensure that your workplace

is inaccessible to youngsters

by closing and locking all

entrances when you are

away. NEVER allow untrained

visitors in your shop when

assembling, adjusting or

operating equipment.