Braun MILLENNIUM A5 Manual Do Utilizador

Page 15

Replace damaged parts and resecure as needed.  
Apply Light Oil. 

Resecure, replace or correct as needed.

Inspect lower fold arm pins (2), axles (2) and 
bearings (8) for wear or damage and positive 
securement 

Remove pump module cover and inspect: 
•  Hydraulic hoses, fittings and connections for wear 

or leaks 

•  Harness cables, wires, terminals and connections 

for securement or damage

•  Control board, circuit breaker, power switch and 

lights for securement or damage

Repeat all previously listed inspection, lubrica-
tion and maintenance procedures at 750 cycle 
intervals.

Resecure, replace or correct as needed

Use Braun 32840-QT (Exxon

®

 Univis HVI 26) 

hydraulic fluid (do not mix with Dextron III or other 
hydraulic fluids).  Check fluid level with platform 
lowered fully and roll stop unfolded fully.  Fill 
to within 1/2” of the bottom of the 1 1/2” fill tube 
(neck).

Tighten, repair or replace if needed.

 

 

Tighten, repair or replace if needed.
 

Replace if needed. 

Tighten or replace if needed.

Replace damaged parts and resecure as needed.  
Apply Light Grease during reassembly procedures.

Replace if needed.

Tighten, replace or correct as needed 

Apply Door-Ease or replace if needed.  See Lubri-
cation Diagram.
 
Resecure or replace if needed.     

Resecure, repair or replace if needed.

Check to see that the lift is securely anchored to 
the vehicle and there are no loose bolts, broken 
welds, or stress fractures.

Replace decals if worn, missing or illegible.  Re-
place antiskid if worn or missing.  

Inspect cotter pins on platform pivot pin (2)

Hydraulic Fluid (Pump) - Check level.  Note:  Fluid 
should be changed if there is visible contamination.  
Inspect the hydraulic system (cylinder, hoses, fit-
tings, seals, etc.) for leaks if fluid level is low.

Inspect cylinders, fittings and hydraulic connections 
for wear, damage or leaks 

Inspect outer barrier cylinder hose assembly (hose, 
fasteners, connections, etc.) for wear, damage or 
leakage

Inspect parallel arms, bearings and pivot pins for 
visible wear or damage

Inspect parallel arm pivot pin mounting bolts (8)

Inspect platform pivot pins, bearings and vertical 
arms for wear, damage and positive securement

Inspect upper/lower fold arms, saddle, saddle 
support and associated pivot pins and bearings for 
visible wear or damage

Inspect gas springs (cylinders - 4) for wear or dam-
age, proper operation and positive securement

Inspect saddle bearing (1) and saddle bearing but-
tons (2)

Inspect vertical arm plastic covers   

    

Inspect power cable 
 

 

Mounting 
 

 

 

 

 

 

Decals and Antiskid