Whirlpool W10151595B Manual Do Utilizador

■

A location that allows for proper exhaust installation. See 
“Venting Requirements.”

■

A separate 30-amp circuit.

■

A grounded electrical outlet located within 2 ft (610 mm) of 
either side of the dryer. See “Electrical Requirements.”

■

A sturdy floor to support the dryer weight (dryer and load) 

 

of 115 lbs (52 kg). The combined weight of a companion 
appliance should also be considered.

■

A level floor with a maximum slope of 1" (25 mm) under 

 

entire dryer.

Do not operate your dryer at temperatures below 45ºF (7ºC). 

 

At lower temperatures, the dryer might not shut off at the end 

 

of an automatic cycle. Drying times can be extended.

The dryer must not be installed or stored in an area where it will 
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit, 
installation of the dryer in garages, closets, mobile homes, or 
sleeping quarters. Contact your local building inspector.

The location must be large enough to allow the dryer door to 
open fully.

*

*Most installations require a minimum 5½" (140 mm) clearance 

behind the dryer for the exhaust vent with elbows. See “Venting 
Requirements.”

The following dimensions shown are for the minimum spacing 
allowed when the dryer is to be operated with, or without, the 
Stack Stand Kit. To purchase a Stack Stand Kit, see “Assistance 
or Service.” 

■

Additional spacing should be considered for ease of 
installation and servicing.

■

Additional clearances might be required for wall, door, and 
floor moldings.

■

For closet installation with a door, minimum ventilation 
openings in the top and bottom of the door are required. 
Louvered doors with equivalent ventilation openings are 
acceptable.

■

Companion appliance spacing should also be considered.

This dryer is suitable for mobile home installations. The 
installation must conform to the Manufactured Home 
Construction and Safety Standard, Title 24 CFR, Part 3280 
(formerly the Federal Standard for Mobile Home Construction 
and Safety, Title 245, HUD Part 280).

■

Metal exhaust system hardware, which is available for 
purchase from your dealer.

■

Special provisions must be made in mobile homes to 
introduce outside air into the dryer. The opening (such as a 
nearby window) should be at least twice as large as the dryer 
exhaust opening.