Roberts DreamTime Manual Do Utilizador

1.  Fully extend the wire aerial located on the rear of your clock radio. 

Place the wire antenna so that it is as straight as possible extending 
either above or below the radio.

2. Press 

the 

On / Standby button to switch on your clock radio.

3. Press 

the 

Function button to select the FM band.

4. Press 

the 

Tuning Up or Down button to tune to a station. The 

frequency will change in steps of 50kHz.

 

If the radio is tuned to a station of suffi cient signal strength with RDS 
information present, then the display may change to show the station 
name.

5.  When the waveband end is reached the radio will recommence tuning 

from the opposite waveband end.

6. Set 

the 

Volume to the desired setting.

7.  To switch off your clock radio press the On / Standby button.

Note: (Headphones only)

If you fi nd that FM reception is poor, try repositioning the wire aerial, up 
or down or side to side.

If you fi nd that an FM broadcast has a lot of background hiss, this may 
often be reduced by setting the radio into Mono reception mode for the 
current FM station. Please refer to the section "Stereo / Mono setting - FM" 
on page 27 for further details.

2

3

4

4