Roberts DreamTime Manual Do Utilizador

1.  Place your clock radio on a fl at surface. 

2.  Fully extend the wire aerial located on the rear of your clock radio. 

Place the wire antenna so that it is as straight as possible extending 
either above or below the radio.

 

3.  Plug the mains lead into the mains socket located on the back of your 

clock radio ensuring that the plug is pushed fully into the socket. Plug 
the other end of the mains lead into the wall socket and switch on 
the wall socket. The display will show "ROBERTS" for a few seconds 
and then the display will then show "SCANNING". During this time the 
radio is scanning to fi nd out which DAB radio stations are available. 
After a short time the current time will appear on the display. 

4.  If no stations are found, "NO CLOCK" will be displayed. It may be 

necessary to relocate your clock radio to a position giving better 
reception. You should then carry out a scan to fi nd stations as described 
on page 9.

IMPORTANT:  The mains plug is used as the means of connecting the 
clock radio to the mains supply. The mains socket used for the clock radio 
must remain accessible during normal use. In order to disconnect the clock 
radio from the mains completely, the mains plug should be removed from 
the mains socket outlet completely.

Characters appearing on the LCD display indicate that the clock radio is 
connected to and powered from the mains supply.