Sunbeam STC580 Manual Do Utilizador

EXAMPLE : To store the number 115-1968 under the TELEPHONE KEYPAD  1  button:

1 - Press the  MEMO  button.

4 - Press the TELEPHONE KEYPAD  1  button.

2 - Dial 115-1968.

5 - You have stored 115-1968 under

TELEPHONE KEYPAD   1  button.

3 - Press the  MEMO  button again.

A total of 10 telephone numbers can be programmed in memory.

IMPORTANT: The maximum number of digits that can be stored for any phone number is 16
in PULSE or TONE mode. The maximum number of digits for mixed (TONE and PULSE in
combination) dialing is 15. If you are using a switchboard system to access an outside line
(such as an 8 or 9), press the  PAUSE  button to store a PAUSE.

Press the  TALK  button.

Press the  MEMO  button.

Press the TELEPHONE KEYPAD button for the number you have stored. The stored
number will be dialed automatically.

EXAMPLE: To recall number 115-1968 stored under the TELEPHONE KEYPAD  1  button:

1 - Press the  TALK  button.

3 - Press the TELEPHONE KEYPAD  1  button.

2 - Press the  MEMO  button.

If you get a busy tone, press the  TALK  button to hang up.

Later, press the  TALK  button again.

Listen for a dial tone.

4 . Press the  REDIAL  button. This will automatically redial the last telephone number you

called.

If you only have Pulse (rotary dialing) service in your area set the TONE/PULSE select switch
at the left side of the BASE UNIT to PULSE position. If you want to access tone dialing mode,
press the  Temporary Tone (*)  button on the  HANDSET  and dial the desired number,
subsequent digits will be dialed into Tone mode. Pulse mode will reset after the HANDSET is
returned on-hook.