Omega Lift 13120 Manual Do Utilizador

Lifting
1. Assemble 3 pc. handle, ensure that spring clips

align with slots.

2. Secure the load to prevent inadvertent shifting and

movement.

3. Position the jack near desired lift point.
4. Close the release valve by turning it clockwise until

it is firmly closed.

Note: Use the handle provided with this product or an
authorized replacement handle to ensure proper
release valve operation. When using to lift vehicle, lift
only on the manufacturer’s recommended lift points
and in accordance with the published guidelines in
your vehicle owners manual. Always use jack stands
to support the load immediately after lifting.

5. Insert and secure handle into handle sleeve. Pump

handle until saddle contacts load.

6. Raise load to desired height, then immediately

transfer the load to appropriately rated support
devices such as jack stands.

3

OIPM#13120-TJ2

!

Study, understand, and follow all instructions before
operating this device. Do not exceed rated capacity.
Use only on hard, level surfaces. Lifting device only.
Immediately after lifting, support the vehicle with
appropriate means. Failure to heed these markings
may result in personal injury and/or property
damage.

!

Lowering
1. Raise load enough to carefully remove jack stands.
2. Insert handle onto release valve and slowly turn

handle counterclockwise, but no more than 1/2
turn.

3. If load fails to lower:
     a. Carefully transfer the load to another lifting

     device and jack stands.

     b. Carefully remove affected jack, and then the

     jack stands. Lower the load, again by slowly
     turning the release valve no more than 1/2 turn.

4. After removing jack from under the load, push ram

and handle sleeve down to reduce exposure to rust
and contamination.

Be sure all tools and personnel are clear before
lowering load. No alterations shall be made to this
device. Only attachments and/or adapters supplied
by the manufacturer shall be used.

     

To avoid crushing and related injuries:

NEVER work on, under or around a load supported
only by a jack. ALWAYS use adequately rated jack
stands.