BMW 2009 X3 xDrive30i Manual Do Proprietário

Opening and closing

If you wish, you can have this special fea-
ture deactivated on vehicles without an

alarm system.

Do not lock the vehicle from the outside
when people are in it since they will be

unable to unlock it from the inside if they do not
know the special procedure.

If you unlock the vehicle, but do not open
any doors, the central locking system

automatically relocks the vehicle after a short
time. If you wish, you can have this special fea-
ture activated/deactivated.

Switching off tilt alarm sensor* and

interior motion sensor*

Press the

button again directly after

locking.
For details, refer to page

Switching on interior lamps

With the vehicle locked:
Press the

button.

You can also use this function to locate your
vehicle in parking garages etc.

Panic mode*

You can also trigger the alarm system

in case

of danger:
Press the

button for at least 3 seconds.

Deactivating alarm

When vehicle is unlocked
Press button for unlocking or locking

When vehicle is locked
Press button for unlocking

Unlocking liftgate

Press the

button.

The liftgate will open slightly, regardless of
whether it was previously locked or unlocked.

If you wish, you can have the liftgate open
only after the vehicle has been unlocked.

You may have this function activated/deacti-
vated.

To avoid damage, make sure there is suf-
ficient space when opening the liftgate.

A previously locked liftgate is also locked again
after closing.
Before and after a drive, make sure that the lift-
gate has not been inadvertently released.

Malfunction

The remote control may malfunction due to
local radio waves.
Should this occur, use the master key to unlock
and relock the vehicle via the door lock.
If it is no longer possible to lock the vehicle
using the remote control, its battery is dis-
charged. Use this remote control during an
extended drive; this will recharge the battery,
refer to page

For US owners only

The transmitter and receiver units comply with
part 15 of the FCC/Federal Communications
Commission regulations. Operation is gov-
erned by the following:
FCC ID:
LX8EWS
LX8FZVS
LX8FZVE
Compliance statement:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:

This device must not cause harmful inter-
ference, and

this device must accept any interference
received, including interference that may
cause undesired operation.

Any unauthorized modifications or
changes to these devices could void the

user's authority to operate this equipment.