BMW 2009 X3 xDrive30i Manual Do Proprietário

70

If the system cannot be operated after 
repeated programming, check whether 

the original hand-held transmitter uses an alter-
nating-code system. To do so, either read the 
instructions of the original hand-held transmit-
ter or press and hold down the programmed 
memory button

1 of the integrated universal 

remote control. If the LED

2 on the integrated 

universal remote control flashes rapidly for a 
short time then lights up for approx. 2 seconds, 
this indicates that the original hand-held trans-
mitter uses an alternating-code system. In the 
case of an alternating-code system, program 
the memory buttons

1 as described in the sec-

tion below on alternating-code hand-held 
transmitters.

<

Consult the operating instructions of the unit 
you wish to set when programming the inte-
grated universal remote control. You will find 
information there on the possibilities for syn-
chronization.
When programming hand-held transmitters 
that employ an alternating code, please follow 
these additional instructions:

Programming will be easier with the aid of 
a second person.

<

1.

Park your vehicle within the range of the 
remote-controlled equipment.

2.

Program the integrated universal remote 
control as described above in the section on 
Fixed-code hand-held transmitters.

3.

Locate the button on the receiver of the 
equipment to be set, e.g. on its drive unit.

4.

Press the button on the receiver of the 
device you want to set up. After step 4, you 
have approx. 30 seconds for step 5.

5.

Press the programmed memory button

1 

of the integrated universal remote control 
three times.

The corresponding memory button

1 is now 

programmed with the signal of the original 
hand-held transmitter.

If you have questions, please contact your 
BMW Sports Activity Vehicle Center.

<

Press the left and right memory button

1 for 

approx. 20 seconds until the LED

2 flashes rap-

idly: 
All stored programs are deleted.

1.

Hold the original hand-held transmitter at a 
distance of approx. 4 in/10 cm to 12 in/
30 cm from the memory buttons

1.

The required distance between the 
hand-held transmitter and memory 

buttons

1 depends on the relevant system 

of the original hand-held transmitter used.

<

2.

Press the desired memory button

1 of the 

integrated universal remote control.

3.

When the LED 

2 flashes slowly after approx. 

20 seconds, press the transmit button of 
the original hand-held transmitter. Release 
both buttons as soon as the LED

2 flashes 

rapidly. If the LED

2 does not flash rapidly 

after approx. 15 seconds, then change the 
distance and repeat the step.

1 Adjusting button
2 Display
The display indicates the cardinal or intercardi-
nal direction in which you are currently driving.

Online Edition for Part no. 01 41 2 601 104 - © 08/08 BMW AG