Garmin Columbia 350/400 Manual Do Utilizador
Garmin G1000 Cockpit Reference Guide for the Columbia 350/400
9-2
SECTION 9 – PROCEDURES
to highlight the desired transition waypoint and
press the ENT Key.
press the ENT Key.
Figure 9-4 Select Arrival Transition
7) A third window is displayed listing the available
runways. Turn either FMS Knob to select the
desired runway and press the ENT Key.
desired runway and press the ENT Key.
Figure 9-5 Select Arrival Runway
8) With ‘LOAD?’ highlighted, press the ENT Key.
If a flight plan is active, the selected arrival
procedure is inserted after the destination
airport and becomes part of the active flight
plan. If no flight plan is active when the arrival
is loaded, the arrival procedure will become the
active flight plan.
procedure is inserted after the destination
airport and becomes part of the active flight
plan. If no flight plan is active when the arrival
is loaded, the arrival procedure will become the
active flight plan.
9.2 APPROACHES
Not all approaches in the database are approved for GPS
use. When selecting an approach, a “GPS” designation to
the right of the procedure name indicates the procedure
can be flown using the GPS receiver. Some procedures
will not have this designation, meaning the GPS receiver
can be used for supplemental navigation guidance only.
the right of the procedure name indicates the procedure
can be flown using the GPS receiver. Some procedures
will not have this designation, meaning the GPS receiver
can be used for supplemental navigation guidance only.
If the GPS receiver cannot be used for primary guidance,
the appropriate navigation receiver must be used for the
selected approach (e.g., VOR or ILS). The final course
segment of ILS approaches, for example, must be flown
by tuning the Nav receiver to the proper frequency and
selecting that Nav receiver on the CDI.
the appropriate navigation receiver must be used for the
selected approach (e.g., VOR or ILS). The final course
segment of ILS approaches, for example, must be flown
by tuning the Nav receiver to the proper frequency and
selecting that Nav receiver on the CDI.
Load and/or Activate an Approach Procedure
1) With the Navigation Map Page displayed, press
the FPL Key.
2) Select the LD APR Softkey. If a flight plan is
active, the destination airport will be displayed
as the default. A list of available approaches
is also displayed.
as the default. A list of available approaches
is also displayed.
3) If no flight plan is active, use the FMS Knobs
to enter the identifier of the desired airport.
Press the ENT Key.
Press the ENT Key.
4) Turn the large FMS Knob to highlight the
Approach field. Turn the small FMS Knob to
display a list of available approaches.
display a list of available approaches.
Figure 9-6 Selecting an Approach Procedure
5) Turn either FMS Knob to highlight the desired
approach. Press the ENT Key.