Garmin Columbia 350/400 Manual Do Utilizador
Garmin G1000 Cockpit Reference Guide for the Columbia 350/400
10-2
SECTION 10 – HAZARD
AVOIDANCE
At a map range of less than 25 nm, Stormscope
lightning data is not displayed, but can still be present.
The presence of Stormscope lightning data is indicated
by the annunciation ‘LTNG < 25 nm’ in the upper right
corner.
The presence of Stormscope lightning data is indicated
by the annunciation ‘LTNG < 25 nm’ in the upper right
corner.
Figure 10-5 Lightning Display Range Annunciation
Select ‘cell’ or ‘strike’ as the Stormscope
lightning mode on the Navigation Map:
lightning mode on the Navigation Map:
1) From the Navigation Map Page, press the
MENU Key. Select Map Setup and press the
ENT Key.
ENT Key.
2) Turn the small FMS Knob to select ‘Weather’
and press the ENT Key.
3) Turn the large FMS Knob to select ‘STRMSCP
MODE’.
4) Turn either FMS Knob to display the Cell/Strike
Window.
5) Turn either FMS Knob to select ‘Cell’ or ‘Strike’.
Press the ENT Key.
6) Push the FMS Knob to return to the Navigation
Map Page.
Clear Stormscope lightning data from the
Navigation Map Page:
Navigation Map Page:
1) Press the MENU Key (with the Navigation Map
Page displayed).
2) Turn either FMS Knob to highlight the ‘Clear
Lightning Data’ field and press the ENT Key.
Stormscope Page
1) Turn the large FMS Knob until the Map Page
group is selected.
2) Turn the small FMS Knob until the Stormscope
Page is selected.
Figure 10-6 Stormscope Page
Change the Stormscope lightning mode
between ‘cell’ and ‘strike’:
between ‘cell’ and ‘strike’:
1) Select the Stormscope Page.
2) Select the MODE Softkey. The CELL and STRIKE
2) Select the MODE Softkey. The CELL and STRIKE
Softkeys are displayed. Select the CELL Softkey
to display ‘CELL’ data or select the STRIKE
Softkey to display ‘STRIKE’ data. ‘CELL’ or
‘STRIKE’ is displayed in the mode box located in
the upper left corner of the Stormscope Page.
to display ‘CELL’ data or select the STRIKE
Softkey to display ‘STRIKE’ data. ‘CELL’ or
‘STRIKE’ is displayed in the mode box located in
the upper left corner of the Stormscope Page.
NOTE: “Cell mode” uses a clustering program to
identify clusters of electrical activity that indicate
cells.