Grindmaster CC-302-20 Manual Do Utilizador

1.  Left motor may be changed with 61116-01 (round motor) if you install a single pole switch    

(part # 61847) in place of the existing power switch.

2.  Middle motor may be changed with 61116-01 directly.
3.  Right motor can only be changed with 61116R (Oval (double-D) shaped motor).  

1.  Place motor in mounting location, install lock washers and loosely tighten acorn nuts on motor mounting 

studs. Hold motor while shaft is centered inside hole then tighten nuts securely. 

2.  Install white slinger washer over the motor shaft and up to hopper mounting bracket.
3.  Lubricate inside of whipper base then install over the motor shaft and check alignment of holes. If alignment 

is off, rotate base 180° to make sure holes line up. Hold base securely, and carefully tighten mounting 
screws.

4.  Check the motor shaft to ensure it can turn freely with fingers. If shaft is still hard to turn, reposition motor 

and repeat.

1

61523

Whipper Base 

Assembly

1

61116-01  or  

61867

Motor, Whipper, 

120V

1 

62529

Instruction Sheet

1

61523

Whipper Base

Assembly

1

61117-01

Motor, Whipper,

230V

1 

62529

Instruction Sheet

WARNING: This procedure should be performed by a qualified service technician.

1. Turn the power switch to the "OFF" position.
2. Drain the water tank (refer to instructions on page 12). Do not replace the drain hose plug and clamp until 

further instructed.

3. Turn the power switch to the "ON" position. The ready light should turn itself "ON" within 12 seconds. The 

12 second delay signals that the heating element has been disabled due to the lack of water in the tank 
after it is drained. 

IMPORTANT: If the ready light does not turn itself "ON" within 12 seconds, turn the power "OFF" to avoid 
burning out the heating element.  
4. Listen for the inlet valve to energize. To purge the inlet valve and water inlet tube, apply 10-20 psi 

compressed air to the inlet valve connection for 10 to 20 seconds while the inlet valve is energized.  

NOTE: Do not energize the inlet valve for more than 5 minutes at a time. Otherwise, the watchdog timer will 
disable the inlet valve. If this occurs, reset the machine by flipping the power switch “OFF” then “ON”.
5. After the inlet valve and water inlet tube are purged, purge the dump valves and dispense lines.  While 

applying 10-20 psi compressed air to the inlet valve connection, press and hold each dispense button for 
1-2 seconds.    

6. Turn the power switch to the “OFF” position. Replace the drain hose plug and clamp. Reposition the drain 

hose inside the hose clip on the left side wall.

7. Reassemble the front access panel and drain tray.

7. Once the tank is empty, securely replace the plug and clamp on the end of the hose. Reposition the drain 

hose inside the hose clip on the left side wall. 

8. Reassemble the front access panel and drain tray.