Grindmaster CC-302-20 Manual Do Utilizador

On models with manual dispense switches (Refer to serial tag to verify model number of your machine)
1.   Place cup under the selected drink dispense nozzle.
2. Push and hold the appropriate switch on the touchpad until cup is 2/3 full and then release switch.

On models with portion control (single portion or 3 portion per head): (optional on PIC 2, 3, & 4 only)
1.   Place cup under the selected drink dispense nozzle.
2.   Push appropriate switch on the touch pad, then release to dispense one preset serving.  (see Portion 

Control Adjustment to set portion size)

NOTE: Portion may be cancelled by push and release of the switch during dispensing.

CAUTION: Cup must rest flat on tray with a 1/4” (6 mm) clearance between cup and spout. Contents can
cause severe burns if handled improperly.

If machine is a manual dispense, there are no portion control adjustments to be made. (Please refer to serial tag to
reference model number.)

SETTING SINGLE PORTION CONTROL
1.   Place a cup under the selected drink dispense nozzle.
2. Press and hold the dispense switch.
3.   After a 10 second time delay, the machine is triggered into program mode and will begin dispensing.
4.   Continue pressing the button until cup is approximately 2/3 full, then release the switch to prevent overfill. 

The elapsed portion dispense time is saved to memory and will remain until the dispense switch is 
reprogrammed.

5.   Check the portion size by placing an empty cup under the desired dispense nozzle, then press and release 

the dispense switch. The machine will dispense the preprogrammed portion size.

6.   If the portion size is incorrect, repeat above steps until the desired portion size is achieved. Each dispense

switch needs to be set separately.

SETTING THREE PORTION SIZES PER HEAD (optional on PIC 2/3/4 only)
1.   Place a cup under the selected drink dispense nozzle.
2.   Press and hold the size button on the touch pad that you wish to program or set. (Hold button throughout 

entire procedure.)

3. Press and release the manual (top-off) button. After releasing the manual (top-off) button, the 10-second 

delay is activated.

4.   Continue pressing the size button until cup is approximately 2/3 full, then release the switch to prevent 

overfill. The elapsed portion dispense time is saved to memory and will remain until the dispense switch is 
reprogrammed.

5.   Check the portion size by placing an empty cup under the desired dispense nozzle, then press and release 

the dispense switch. The machine will dispense the preprogrammed portion size.

6.   If the portion size is incorrect, repeat above steps until the desired portion size is achieved. Each portion size for

each head needs to be set separately.



(cont.)

NOTE: Do not let the end of the hose touch the bottom of the container. Shorten the hose if necessary. If you 
need a longer hose, remove the back access panel, unclamp existing hose, replace with longer hose and 
replace clamp.

3. Proceed with fifth step under Start Up for Standard Units

.