Dyson Airblade Tap Manual Do Proprietário

3

WARNING:

This unit contains substances known to the state of California to cause cancer, 

birth defects and other reproductive harm. Wash hand after installation or repair 

of this unit.

READ AND SAVE THESE INSTRUCTIONS

LOOkING AfTER yOUR HAND DRyER
WARNING

This product is not to be used in sinks where a plug is fitted. Before engaging the water 

flow ensure that the plughole is clear of any obstructions and that water can drain freely.

HOW TO USE

1. Place your hands beneath the center of the tap and water will flow automatically for as long 

as the hands remain in place.

2. Place your hands to either side of the center tap to activate the hand dryer, creating sheets of 

air to scrape water from your hands.

3. Move your hands backwards and forwards slowly through the air, turning them over so both 

back and front are exposed to the airflow.

TROUBLESHOOTING GUIDE

WARNING: RISk Of ELECTRIC SHOCk.

Problem

Action

The hand dryer fails to start.

Check fuse/circuit breaker is working and that the 

power and water supply are connected. Must be 

performed by a qualified electrician.

Ensure the cleaning cap is removed and that the 

sensors are clean and unobstructed.

If a safe method of switching is available, turn the 

unit on and off. If a safe method is not available, a 

qualified electrician must perform this task.

The hand dryer is turning on and 

off erratically.

Ensure sensors are clean.

Check that the sensor cable from the tap is securely 

connected. Must be performed by a qualified 

electrician.

The hand dryer sometimes cuts out 

when in use but resumes operation 

after a period of time.

Check the air inlet is clean and free of dust.

If the air inlet is dusty simply remove dust.

Ensure that the air inlet is free from obstructions and 

has sufficient clearance (see installation instructions).

The dry time of the hand dryer has 

increased.

The air flow from the hand dryer is 

running hotter than usual.

Inspect the inlet grille for dust and remove. Inspect 

filter and change if required.

Ensure that the hose is securely attached to the base of 

the tap and no leaks are present. Must be performed 

by a qualified electrician.

Air is continuously running from the 

hand dryer.

Ensure sensors are clean and free from any 

obstructions