Brocade Communications Systems Switch 53-1001762-01 Manual Do Utilizador
196
Converged Enhanced Ethernet Command Reference
53-1001762-01
qos cos-traffic-class
12
DRAFT: BROCADE CONFIDENTIAL
qos cos-traffic-class
Applies a CoS-to-Traffic Class QoS map on an interface.
Synopsis
qos cos-traffic-class name
no qos cos-traffic-class
Operands
name
Specifies the name of a previously created CoS-to-Traffic Class QoS map. Only
one CoS-to-Traffic Class QoS map can exist at a time. An existing
CoS-to-Traffic Class QoS map must be removed before a new one can be
applied.
one CoS-to-Traffic Class QoS map can exist at a time. An existing
CoS-to-Traffic Class QoS map must be removed before a new one can be
applied.
Defaults
There is no explicit CoS-to-Traffic Class QoS map applied; the implicit behavior is to match the IEEE
802.1Q recommendations for systems supporting eight Traffic Classes.
802.1Q recommendations for systems supporting eight Traffic Classes.
Command
Modes
Interface configuration mode
Description
Use this command to apply a CoS-to-Traffic Class QoS map to an interface. Use the no qos
cos-traffic-class command to remove the CoS-to-Traffic Class mapping.
cos-traffic-class command to remove the CoS-to-Traffic Class mapping.
Usage
Guidelines
This command is not available when the interface is in the CEE Provisioning mode.
Examples
To apply a CoS-to-Traffic Class QoS map to an interface:
switch(conf-if-te-0/1)#qos cos-traffic-class test
See Also
qos map cos-traffic-class, qos trust, qos cos-mutation, show qos maps