BMW 2005 745i Sedan Manual Do Proprietário

Replacing comp

onents

202

Releasing lamp cover

The illustration shows the left side of the
engine compartment.

High beams

Press the tab down, refer to arrow.

Always wear gloves and eye protec-
tion – the atmosphere within the bulb

is pressurized. Failure to observe this pre-
caution can lead to personal injury should
the bulb be damaged.

1 High beams

H7 bulb, 55 watts

Remove the cover

Turn the bulb holder to the left and
remove

Remove and replace the bulb.

Xenon lamps

The service life of these bulbs is very long
and the probability of a failure is very low,
provided that they are not switched on and
off an unusual number of times. In the
unlikely event that one of these lamps
should fail, you can respond by switching
on your fog lamps and proceeding care-
fully, where allowed by law.

Only have work on the xenon lighting
system including bulb changes car-

ried out by a BMW center or a workshop
that uses personnel trained in accordance
with BMW requirements. Due to the high
voltage involved, there is a danger to life
and limb when work is carried out improp-
erly.

Parking and standing lamps

In the event of a malfunction, please con-
tact your BMW center.

Turn signals, front

Two bulbs, 3457AK or 3457NAK

Turn the bulb holder to the left and
remove

Apply gentle pressure to the bulb while
turning it to the left for removal and
replacement.

Side-mounted turn signals

Bulb 5 watts, W 5 W

Press against the front edge of the lamp
with the tip of your finger, then push it to
the rear and release the detent at the
front

Turn the lamp 90

3 and remove

Turn the bulb holder to the left and
remove

Extract the bulb for replacement.