BMW 2005 745i Sedan Manual Do Proprietário
Techn
o
lo
gy
fo
r co
mfo
rt, co
nveni
e
nce
an
d safet
y
96
The check of the tire inflation pressure is
based on monitoring the relative speeds of
the wheels. A flat tire is detected and
reported on the basis of a deviation in cer-
tain speed ratios.
based on monitoring the relative speeds of
the wheels. A flat tire is detected and
reported on the basis of a deviation in cer-
tain speed ratios.
Functional requirements
So that the Flat Tire Monitor can learn the
correct inflation pressure, please perform
the following:
correct inflation pressure, please perform
the following:
1.
Check the inflation pressures in all tires
2.
Compare with the inflation pressure
table on page
table on page
and correct if neces-
sary
3.
Initialize the system.
System limits
The Flat Tire Monitor cannot indicate
sudden severe tire damage caused by
sudden severe tire damage caused by
outside factors and does not detect a natu-
ral, even pressure drop in all four tires.
ral, even pressure drop in all four tires.
<
In the following situations, on the other
hand, there can be delays in detecting tire
pressure losses, and even system failure:
hand, there can be delays in detecting tire
pressure losses, and even system failure:
>
When you are driving on snow-covered
or slippery road surfaces
or slippery road surfaces
>
In the case of performance-oriented
driving: slip on the drive wheels, high
lateral acceleration
driving: slip on the drive wheels, high
lateral acceleration
>
False alarms and undetected loss of
pressure may occur when you are driv-
ing with snow chains fitted.
pressure may occur when you are driv-
ing with snow chains fitted.
Initializing system
Perform the initialization immediately
after correcting the inflation pressure,
after correcting the inflation pressure,
changing a tire or changing a wheel or all
wheels. A drive is necessary for this pur-
pose.
wheels. A drive is necessary for this pur-
pose.
<
1.
Start the engine, but do not drive off
2.
Select "RPA" from the "Settings" menu
and confirm your selection. The initial-
ization menu appears
and confirm your selection. The initial-
ization menu appears
3.
Select "SET" and confirm your selection
4.
Drive off.
"FTM is being initialized" is displayed as the
status.
status.
It takes at least 10 minutes before the Flat
Tire Monitor can detect and report a flat
tire.
Tire Monitor can detect and report a flat
tire.
When driving with snow chains, do
not initialize the system.
not initialize the system.
<
Select
and confirm to exit from the
menu.
Indication of a flat tire
The warning lamp lights up red,
accompanied by a status message
in the Check Control. In addition, an
accompanied by a status message
in the Check Control. In addition, an
acoustic signal sounds. A flat tire or a major
air loss has occurred.
air loss has occurred.
1.
Reduce speed and stop the vehicle
carefully. Avoid sudden braking and
steering maneuvers
carefully. Avoid sudden braking and
steering maneuvers
2.
Identify damaged tire
If identification is not possible,
contact your BMW center.
contact your BMW center.
<
3.
Replace the damaged tire, refer to
Changing wheels on page
Changing wheels on page
.
Online Edition for Part-No. 01 41 0 159 154 - © 09/04 BMW AG