Behringer Super-X Pro CX3400 Manual Do Utilizador

SUPER-X PRO CX3400 User Manual

(1)

(3)

(5)

(2)

(6)

(8)

(9) (10)

(12) (13) (14)

(15)

Fig. 2.4: Active control elements on the rear panel of the SUPER-X PRO for 2-way stereo operation 

(1)

  Use the enclosed power cord to connect the unit to the mains.

(2)

  FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local  

 

voltage matches the voltage indicated on the unit, before you attempt to  

 

connect and operate the CX3400. Blown fuses may only be replaced by fuses  

 

of the same type and rating. Some models allow for inserting the fuse  

 

holder in two different positions, in order to switch over from 230 V to 

 

115 V operation, and vice versa. Please note that for 115 V operation 

 

outside Europe, you need to use a fuse of a higher rating 

 

(see chapter 4 “Installation”).

(3)

  and  

(10)

  HIGH OUTPUT connector. Output for the High band signal.

(5)

  and  

(12)

  LOW (LF SUM) OUTPUT connector. Output for the 

 

Low band signal.

(6)

  and  

(13)

  XOVER FREQ. button. This button serves to switch over the control  

 

range of the front-panel LOW/HIGH OVER FREQ. control from 44 to 930 Hz 

 

or 440 Hz to 9.3 kHz.

(8) 

MODE button. In stereo 2-way mode, the first button must be pressed, 

 

the second released. Please observe the labels on the rear panel of the unit.

(9)

  LOW SUM button. In stereo mode, the two Low paths can be summed  

 

with the LOW SUM button and routed to the Low output of channel 1, 

 

which is particularly useful in systems using additional subwoofers.

(14)

 INPUT connector. Input signal connector.

(15)

  SERIAL NUMBER. Please take the time to have the warranty card filled out  

 

completely by your specialized dealer, and return it within 14 days after the  

 

date of purchase, so as to be entitled to benefit from our extended warranty.  

 

Or use our online registration option available on the Internet 

 

at behringer.com.

2.3.2  Stereo 3-way operation
First, activate stereo 3-way mode by means of the two MODE buttons on the 

rear panel. The STEREO-LED on the front panel, above the LOW CUT button in 

channel 2, lights up.

Fig. 2.5: Proper selection of the two MODE switches for stereo 3-way operation

Subsequently, the LEDs above the active controls on the front panel light up, 

signaling which controls are active in the operating mode you just selected. 

The functions of these controls can be seen from the second strip label. 

In stereo mode, both channels perform the same functions.