Whirlpool 9762365A Manual Do Utilizador

Página de 28
25
To Remove:
1. Open the oven door. Insert door removal pins, included with 
your range, into both hinge hangers. Do not remove the pins 
while the door is removed from the range.
2. Slowly close the door until it rests against the door removal 
pins.
3. Grasp the door on the sides with your fingers on the front of 
the door and your thumbs on the inside surface.
4. Pull door straight up, then toward you. Hinge hangers will 
slide out of front frame hinge slot. Do not remove door 
removal pins until the door is replaced on the range.
To Replace:
1. Grasp the door on the sides with your fingers on the front of 
the door and your thumbs on its inside surface.
2. Hold oven door so that the top edge of each hinge hanger is 
horizontal. Insert hinge hangers into the front frame hinge 
slots.
3. Tilt top of door toward range. Slide hinge hangers down onto 
front frame support pins. Make sure the hinge hangers are 
fully seated and engaged on the support pins.
4. Insert the door stop clip with its angular surface at the top of 
the frame hinge slot, then push in the bottom of the clip until 
its flanges are flush with the front frame.
5. Open the door completely and remove the door removal pins. 
Save door removal pins for future use.
6. Close the door.
Storage Drawer
The storage drawer can be removed. Before removing, make sure 
drawer is cool and empty.
To Remove:
1. Pull the storage drawer straight back past the drawer stop 
notch and the end of the side rails.
2. Lift up the back of the drawer and pull the drawer out.
To Replace:
1. Lift up the back of the drawer and place it inside the range in 
its fully forward position.
2. Lift up the front of the drawer to a level position.
3. Slowly push the drawer into the range until the drawer side 
rails engage with the gap in the drawer glides.
4. Once the drawer is fully engaged on both sides, slide the 
drawer back into the closed position. 
NOTE: When removing and replacing the storage drawer, a slight 
push may be needed to move the drawer stop notch past the 
drawer glides.
A. Removal pins
B. Hinge hanger
A. Hinge hanger
B. Door frame hinge
C. Support pins
A
B
A
B
C
A. Drawer stop notch
B. End of side rail
A. Engage drawer glide
A
B
A