Whirlpool FEP310K Manual Do Utilizador

Página de 16
7
COOKTOP USE
Control Knobs
The control knobs can be set anywhere between HI and LO. Push 
in and turn to setting. The surface cooking area locator shows 
which element is turned on. Use the following chart as a guide 
when setting heat levels.
Coil Elements and 
Burner Bowls
Coil elements should be level for optimal cooking results. Burner 
bowls, when clean, reflect heat back to the cookware. They also 
help catch spills.
Cookware should not extend more than 1 in. (2.5 cm) over the 
coil element. If cookware is uneven or too large, it can produce 
excess heat causing the burner bowl to change color. For more 
information, see the “General Cleaning” section.
Before removing or replacing coil elements and burner bowls, 
make sure they are cool and the control knobs are off.
To Remove:
1.
Push in the edge of coil element toward the receptacle. Then 
lift it just enough to clear the burner bowl.
2.
Pull the coil element straight away from the receptacle.
3.
Lift out the burner bowl.
To Replace:
1.
Line up openings in the burner bowl with the coil element 
receptacle.
2.
Holding the coil element as level as possible, carefully push 
coil element terminal into the receptacle.
3.
When the terminal is pushed into the receptacle as far as it 
will go, push down the edge of the coil element opposite the 
receptacle.
SETTING
RECOMMENDED USE
HI
Start food cooking.
Bring liquid to a boil.
6-8
[MED- HI]
Hold a rapid boil.
Quickly brown or sear food.
5
[MED]
Maintain a slow boil.
Fry or sauté foods.
Cook soups, sauces and gravies.
2-4
[MED- LO]
Stew or steam food.
Simmer.
LO
Keep food warm.
Melt chocolate or butter.
WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
REMEMBER: When range is in use or during the 
Self-Cleaning cycle, the entire cooktop area may 
become hot.