Whirlpool FGP300JN0 Manual Do Utilizador

Remove cardboard shipping base from

under range. Open broiler door. Use a 3/8”
drive ratchet to lower rear leveling legs one-
half turn. Use channel lock pliers to lower front
leveling legs one-half turn. 

If installing the range in a mobile 

home, you MUST secure the range to the floor.
Any method of securing the range is adequate as
long as it conforms to the “Manufactured Home
Construction and Safety Standard,” Page 2.

Place rack in oven. Place level on rack,

first side to side; then front to back. 
If range is not level, pull range forward until
rear leveling leg is removed from the anti-tip
bracket. Use 3/8" drive ratchet and channel
lock pliers to adjust leveling legs up or down
until range is level. Push range back into
position. Check that rear leveling leg is
engaged in anti-tip bracket.

If a flexible appliance connector is

used, be certain connector is not kinked.

Check that all control knobs are in the

“OFF” position.

Open the manual shutoff valve in the

gas supply line. Wait a few minutes for gas to
move through the gas line.

Use a brush and liquid detergent 

to test all gas connections. Bubbles around
connections will indicate a leak. If a leak appears,
shut off gas valve controls and tighten
connections. Then check connections again.
Never test for gas leaks with a match or other
flame. Clean all detergent from gas connections.
Close broiler door.

If pilot needs adjusting, remove

burner grates, burners and screws. Lift
cooktop. 
Note: There is no cooktop support rod.

Light the burner pilots.

1.  Remove burner grates.

2. Place a lit match through the small pilot

holes in the cooktop located between front
and rear burners.

3. After lighting, you must see a pilot flame

in each pilot hole.

Note: The pilot flames should be 1/2” to 
5/8” inch high.

Assemble the flexible connector to the

gas supply pipe to the pressure regulator
connection fitting, using the adapter fittings
provided with the flexible connector. Use pipe-
joint compound made for use with L.P. gas to
seal all pipe thread connections. 

Adjust pilot adjustment screw until

pilot flame tips are 1/2" to 5/8” high and
centered in the pilot housings. If the flame is
too high, carbon (soot) will form on
underside of maintop.

Open broiler door. Hold a match to

the opening in the top of the pilot area at the
rear of the oven burner. No pilot adjustments
are needed. Close broiler door.

• Look for the 

anti-tip bracket  
securely attached to 
floor.

• Slide range back so rear range foot is under 

anti-tip bracket.