Western Telematic Remote Power Boot Switch Manual Do Utilizador

Enter Parameters:  To define parameters, such as the Location I.D., Power-Up
Default, and Plug Labels, type /P  [Enter] and refer to 

5.  

Set Plugs to Default:  To set all plugs to the Power-Up Defaults, type /D  [Enter].
Note that if the Default String includes missing or invalid characters, the /D command
will not function.

6.  

Exit:  To exit from command mode, type /X  [Enter].

7.  

Note:   When the /n ON/OFF/BOOT command is invoked, the port (n) must
be specified by number.  The Port Label cannot be used to specify the desired
port.

To Switch Plug 3 ON, type /3 ON [Enter].

●   

To switch all plugs ON, type /* ON [Enter].

●   

To switch plug 5 OFF, type /5 OFF [Enter].

●   

To switch all plugs OFF, type /* OFF [Enter].

●   

To initiate a boot cycle at Plug 2, type /2 BOOT [Enter].

●   

To initiate a boot cycle at all plugs, type /* BOOT [Enter].

●   

Switched Power Plugs:   5 code-selectable AC plugs rated 15 amps max. Each. Total
switched power for all plugs not to exceed 15 amps.  Unit initially powers up to ON
condition.

●   

DB9 Connector:   A 9 Pin Male connector wired in a DTE configuration.

Pin Signal I/O
1

DCD

Carrier Detect

❍   

●   

RPB+; Remote Power Boot Switch -- User's Guide

file:///C|/WEBPAGE/guides/rpbp/build/rpbpguid.htm (10 of 12) [3/9/2000 5:08:11 PM]