hussman Water Heater rhr-hex Manual Do Utilizador
IGHT-RHR, RHR2-HEX-9911
4
WIRING COLOR CODE
L1
BLACK
L2
ORANGE
L3
BLUE
NEUTRAL
WHITE
NOTE: High Leg Connection
Orange Only
ELECTRICAL CIRCUIT IDENTIFICATION
Standard lighting for all models will be fluorescent lamps
located within the case at the top.
The switch controlling the lights and heaters are located
within an access panel on the side of the case.
located within the case at the top.
The switch controlling the lights and heaters are located
within an access panel on the side of the case.
BEFORE SERVICING
ALWAYS DISCONNECT ELECTRICAL
POWER AT THE MAIN DISCONNECT
WHEN SERVICING OR REPLACING ANY
ELECTRICAL COMPONENT.
This includes (but not limited to) Fans, Heat-
ers, Thermostats, and Lights.
FIELD WIRING & SERIAL PLATE AMPERAGE
Field Wiring must be sized for component amperes
printed on the serial plate. Actual ampere draw may be
less than specified. Field wiring from the
printed on the serial plate. Actual ampere draw may be
less than specified. Field wiring from the
Field wiring from the where??
Most component amperes are correctly listed in the
“Case Specs” section, but due to parts availability they
may vary slightly. Always check the serial plate for the
actual loads.
“Case Specs” section, but due to parts availability they
may vary slightly. Always check the serial plate for the
actual loads.
BALLAST LOCATION
RHR-HEX 6' &
(4')
Self-Service Hot
Control Panel
Ballast
Ballast
(one for each light)
RHR2-HEX 6' &
(4')
Self-Service Hot
Scale = 1/2"
Control
Panel
Ballast
Ballast
(one for each light)
Ballast for shelves
Electrical