Gyration Compact Keyboard Manual Do Utilizador

power on your computer. Your operating system should 

detect the new hardware device and initiate the installa-

tion procedure. Continue to follow the standard USB 

device installation screens until installation is complete.

Insert four AAA batteries into the keyboard.

Press and hold the Learn button on the receiver for two 

seconds, and then release it. The Status light will blink 

slowly, indicating the receiver is in “Learn Mode.”

Press and release the Teach button located at the top of 

the keyboard. The Status light on the receiver will blink 

rapidly for four seconds, then begin to blink slowly.

At this time, press the Teach button on any additional devices 

(such as a second keyboard, an Ultra Mouse, or a GyroRe-

mote).

To exit Learn Mode, press the Learn button on the 

receiver for two seconds. Otherwise, Learn Mode will 

automatically time out after five minutes.

If more than one Gyration device is being installed on the 

same system, place the receiver into Learn Mode (step 3 

above) and then press the Teach button on each device before 

exiting Learn Mode. However, do not press the Learn button 

on the receiver for each device to be added (see “Keyboard 

Troubleshooting Tips” on page 11).

When the receiver is put into Learn Mode, it erases its mem-

ory of previously learned devices and looks for new devices. 

Therefore when adding a new device to a system, it is neces-

sary to put the receiver into Learn Mode and then press the 

Teach button on all the devices that will be used on the sys-

tem.

After the Teach/Learn sequence is performed, the receiver 

and device(s) will remain synchronized after powering down 

and/or changing channels. It is only necessary to perform the