BEA 10PBJS1 Folheto

75.5093 V1 Aug 2003 [Rev. July 19, 2006] 

 

Page 1 of 1 

DESCRIPTION 

PUSHPLATE 
CLEANING 

USERS GUIDE  

 

INSTALLATION 
INSTRUCTIONS 

COMPANY 
CONTACT 

  
 
 

This pushplate series (10PBJSx) is designed to fit neatly into standard jamb-style pushplate boxes or be mounted 
directly to a door jamb.  The faceplates are made of 1/16” thick stainless steel for durable use.   

 
 
 

1. 

Determine the mounting location of the pushplate.  Use the enclosed mounting template if the pushplate is to be 
attached directly to the door jamb, otherwise, the pushplate will mount directly into a jamb-style box with a 3 ¼” hole 
spacing. 

2. 

If the pushplate is to be mounted directly to the jamb tube, use the template and mark the drill locations by tapping 
the holes with a hammer and center punch.  Then proceed to drill the holes and cut out the recess for the switch. 

3. 

Wire the switch of the pushplates to the door controllers using the normally open contact and common. 

4. 

Fasten the pushplate to the mounting location. 

5. 

Test the pushplate for proper activation. 

 
 

              

 

 

 

 

 
 

 

The pushplates are constructed with durable stainless steel and painted with scuff-resistant coatings.  To clean 
the plates, use only a damp, non-abrasive cloth.  Repeated cleaning with harsh solvents or abrasive materials 
may cause deterioration of the coating.  Please make the end-user aware of this procedure. 
 

 

 
 
 

If after troubleshooting a problem, a satisfactory solution cannot be achieved, please call B.E.A., Inc. 
for further assistance during Eastern Standard Time at 1-800-523-2462 from 8am - 5pm.  
For after-hours, call East Coast: 1-866-836-1863 or 1-800-407-4545 / Mid-West: 1-888-308-8843 /  
West Coast: 1-888-419-2564. DO NOT leave any problem unresolved. If you must wait for the following workday 

to call B.E.A., leave the door inoperable until satisfactory repairs can be made.