England's Stove Works 25-PDVC Instrução De Instalação

IMPORTANT!  READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING 

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED. 

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR 

DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS. 

The following accessories can be added to your unit at anytime after purchase; however, let the 

unit cool down before adding any accessories.  

 

An external wall thermostat (such as our Part # PU-DTSTAT) can be used on our pellet units, as 

long as it is a low-voltage type that works with millivolt systems.  After unplugging the unit, locate the 
jumper wire (J-18) on the bottom of the control panel. The two screws should then be loosened and 
the jumper wire removed from the board. Next, the two thermostat lead wires should be slipped into 
these openings and the screws tightened; the jumper wire should be saved for future operation 
without a thermostat.  

The unit will operate differently once the wall thermostat is connected – we recommend the 

Control Board be set at “9” on Heat Range and Blower Speed while using the thermostat.  Refer to 
the section on “Start-up Procedure” for information on cold starts. 

 

 

There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the stove. 

Match the channel with the correct edge of the ash apron, then remove the protective covering from 
the trim and force the piece onto the edge. Although it should stay in place, stove cement can be 
used to secure it if necessary.   
 

Window trim can be attached by using the provided spring clip(s) and some high temperature 

silicone (optional). Insert the tee end of the spring clip into the channel on the edge of the trim – then, 
turn the clip and set the other end of the clip into the channel.  The spring clip will hold well if it is 
placed on the top edge of the trim before placing the trim in the window of the stove. Place the top 
edge with the clip into the window opening, then push the bottom edge of the trim flush with the 
window.  We also suggest that high temperature silicone be used on the corners, to ensure the trim 
will stay in place. 
 

Accessories can be ordered from the factory at: 

 

(Parts orders ONLY) -- (800) 516-3636, or on our web site: 

. 

 

Questions/Problems:  Please call Technical Support at (800) 245-6489. 

You may also order parts and options, view frequently asked questions and more,

 

on our web site: