Weber 700 Series Manual Do Proprietário

Check that all burner valves are off

You will need: one burner control knob.

Valves are shipped in the OFF position, but you should
check to be sure. Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn
they are off, proceed to the next step. Figure 13.

Install igniter

Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was done to
factory test the ignition system.

The igniter lock nut is on the igniter. 

Insert the top of the igniter up through the large part of the
keyhole in the frame brace. Loosen the igniter lock nut and
slide the igniter into the small part of the keyhole. Tighten
the igniter lock nut. Figure 12.

Note - If the igniter works loose, carefully tighten the igniter
lock nut with an adjustable wrench or pliers.

Igniter lock nut

Frame brace

Keyhole in
frame brace

Connect flexible hose to manifold

You will need: the 12 foot natural gas supply hose and a
3/4 inch wrench.

Thread fitting end of hose onto manifold. Figure 14 (a).
Tighten with wrench.

Small part of keyhole
in frame brace

Frame brace