Woodstock SHOP FOX W1730 Manual Do Utilizador
-14-
SETUP
W1730 Oscillating Edge Sander
Figure 14. Dust port installation.
To mount the dust port, do these steps:
1. Align the dust port holes with the tapped holes on
the side of the sander.
2. Insert the 1/4-20 x 3/8 Phillips head screws with
1/4" washers, through the aligned holes and tighten
as shown in
Figure 14.
Dust Port
To mount the dust port door, do these steps:
1. Align the dust port door hinges with the hinges on
the sander.
2. Insert the hinge pins through the aligned hinges, as
shown in
Figure 15, and tap with a hammer for full
insertion.
3. Close and latch the dust port door.
Dust Port Door
Figure 15. Dust port door.
To mount the dust port cover, do these steps:
1. Align the dust port cover hinges with the hinges on
the sander.
2. Insert the hinge pins through the aligned hinges
(
Figure 16), and tap with a hammer.
3. Shut and latch the dust port cover.
Dust Port Cover
Figure 16. Inserting dust port cover hinge
pin.