Bunn Water Dispenser HW2A Manual Do Utilizador

ELECTRICAL REQUIREMENTS

CAUTION - The dispenser must be unplugged until specified in Initial Set-Up.

The Model HW2 has an attached cordset and requires 2-wire, grounded service rated 120V ac, 15 amp, single

phase, 60 Hz. The Model HW2A requires 2-wire grounded service rated 230V ac, 8 amp, single phase, 50 Hz.

PLUMBING REQUIREMENTS

This dispenser must be connected to a cold water system with operating pressure between 20 and 90 psi

(138 and 620 kPa) from a 1/2” or larger supply line. A shut-off valve should be installed in the line before the

dispenser. Install a regulator in the line when pressure is greater than 90 psi (620 kPa) to reduce it to 50 psi

(345 kPa). The water inlet fitting is 1/4” flare.

NOTE - Bunn-O-Matic recommends 1/4” tubing for installations of less than 25 feet and 3/8” for more than 25

feet from the 1/2” water supply line. A coil of tubing in the water line will facilitate moving the dispenser to clean

the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the dispenser. The size

and shape of the hole made in the supply line by this type of device may restrict water flow.

This equipment must be installed to comply with the International Plumbing Code of the

International Code Council and the Food Code Manual of the Food and Drug Administration

(FDA). For models installed outside the U.S.A., you must comply with the applicable

Plumbing/Sanitation Code for your area.

Plumbing Hook-Up

1. Flush the water line and securely attach it to the bulkhead fitting on the rear of the machine.

2. Turn-on the water supply.

INITIAL SET-UP

CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except

when specified in the instructions.

1. Remove the center rear panel and rotate the control thermostat knob fully counterclockwise to the “OFF”

position and replace the panel.

2. Plug-in the dispenser.

3. Water will automatically flow into the tank to the proper level and shut-off.

4. Unplug the dispenser, remove the center rear panel and rotate the control thermostat knob fully clockwise

to the “ON” position, and replace the panel.

5. Plug-in the dispenser and wait approximately twenty minutes for the water in the tank to heat. The dispenser

is ready for use.

CLEANING

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment.

10052 042409