Brother P-TOUCH PRO DX PT-9200DX Manual Do Utilizador
10
4 Select the desired baud rate, and then click the Next
button.
Normally “115,200 bps” is selected; however,
Normally “115,200 bps” is selected; however,
your computer may not be able to support a baud
rate of 115,200 bps. If this is the case, refer to the
your computer’s instruction manual and select the
maximum possible baud rate.
rate of 115,200 bps. If this is the case, refer to the
your computer’s instruction manual and select the
maximum possible baud rate.
A dialog box appears, asking for confirmation of the
selected baud rate settings.
selected baud rate settings.
5 Check that the baud rate will be changed as desired,
and then click the Next button.
To change the settings, click the Back button, and
To change the settings, click the Back button, and
return to step 4.
A dialog box appears, showing that the baud rate has
been set as specified.
been set as specified.
6 Click the Finish button.
For a USB connection (Windows
®
98/Me/2000 Peofessional/XP only)
With Plug-and-Play, new devices connected to the system
are detected, and their drivers are automatically installed. If
the PT-9200DX is to be connected through the USB port, its
driver will be installed with Plug-and-Play. Be sure to read
the installation instructions described below before install-
ing the file supplied on the CD-ROM.
are detected, and their drivers are automatically installed. If
the PT-9200DX is to be connected through the USB port, its
driver will be installed with Plug-and-Play. Be sure to read
the installation instructions described below before install-
ing the file supplied on the CD-ROM.
Do not connect the P-touch 9200DX to the
computer until you are instructed to do so,
otherwise the PT-9200DX printer driver may not
be installed correctly.
otherwise the PT-9200DX printer driver may not
be installed correctly.
With Windows
®
98/98SE/Me/2000 Professional:
1 Select “USB cable”, and then click the OK button. The
USB message dialog box appears.
2 Click the Next button. A dialog box appears, instruct-
ing you to connect the PT-9200DX to the computer.
3 Connect the PT-9200DX to the computer using the
enclosed USB interface cable as described on page 5,
and then turn on the PT-9200DX. A dialog box
appears, showing that the printer driver has been
installed.
and then turn on the PT-9200DX. A dialog box
appears, showing that the printer driver has been
installed.
For W
indows
®