Wizcom InfoScan TS Elite Manual Do Utilizador

Getting Started 
 

6 

Connecting the Pen to the PC using the USB cable 
automatically activates the power supply from the PC. This 
has the following implications: 

ƒ

  The Pen uses the external power supply when 

connected to the PC, so batteries last longer. 

ƒ

  CAUTION: Unsaved information may be lost if the USB 

ƒ

  Set Auto Shut-Off Time in Preferences is disabled 

when the Pen is connected to the PC. 

To get started: 

1.  Remove the Pen from the protective case. 
2.  Lift the battery cover on the back of the Pen by pushing 

the tab down and out. 

3.  Insert the batteries into the Pen with the positive and 

negative terminals corresponding to the markings on 
the sides of the battery compartment.  
Note: Make sure that your Pen always contains 
batteries, even when connected to the PC. 

4.  Close the battery compartment. 
5.  Remove the protective cover from the Pen tip. 
6.  Turn the Pen on by pressing the red power key. 

The Pen is ready to scan! 

Important: Do not connect the USB cable to the PC before 
installing the WizCom Desktop. 
To install the WizCom Desktop do the following: 

1.  Insert the CD-ROM that was supplied with the Pen.  
2. The 

CD-ROM 

Main Menu

 will appear on the PC 

screen.  

3.  Click on WizCom Desktop Installation and follow the 

instructions for installing the Desktop and the USB 
driver.