WHP Wireless DL360 Manual Do Utilizador

 

Board in Use by Expand Operation ............................................................................................

Board not Attached.....................................................................................................................

− 

/usr/sbin/prtconf 

 

ADU Error Messages (on page 

POST Error Messages ("POST Error Messages and Beep Codes" on page 

Event List Error Messages (on page 

 

Introduction to ADU Error Messages.........................................................................................

Accelerator Board not Detected .................................................................................................

Accelerator Error Log.................................................................................................................

Accelerator Parity Read Errors: X..............................................................................................

Accelerator Parity Write Errors: X .............................................................................................

Accelerator Status: Cache was Automatically Configured During Last Controller Reset .........

Accelerator Status: Data in the Cache was Lost... ......................................................................

Accelerator Status: Dirty Data Detected has Reached Limit......................................................

Accelerator Status: Dirty Data Detected.....................................................................................

Accelerator Status: Excessive ECC Errors Detected in at Least One Cache Line... ..................

Accelerator Status: Excessive ECC Errors Detected in Multiple Cache Lines... .......................

Accelerator Status: Obsolete Data Detected...............................................................................

Accelerator Status: Obsolete Data was Discarded......................................................................

Accelerator Status: Obsolete Data was Flushed (Written) to Drives..........................................

Accelerator Status: Permanently Disabled .................................................................................

Accelerator Status: Possible Data Loss in Cache .......................................................................

Accelerator Status: Temporarily Disabled..................................................................................

Accelerator Status: Unrecognized Status....................................................................................

Accelerator Status: Valid Data Found at Reset ..........................................................................

Accelerator Status: Warranty Alert ............................................................................................

Adapter/NVRAM ID Mismatch .................................................................................................

Array Accelerator Battery Pack X not Fully Charged................................................................

Array Accelerator Battery Pack X Below Reference Voltage (Recharging)..............................