WHP Wireless DL360 Manual Do Utilizador

Attached Drives... .......................................................................................................................

Swapped Cables or Configuration Error Detected. The Maximum Logical Volume Count X...

System Board is Unable to Identify which Slots the Controllers are in .....................................

This Controller Can See the Drives but the Other Controller Can't ...........................................

The Redundant Controllers Installed are not the Same Model...................................................

This Controller Can't See the Drives but the Other Controller Can ...........................................

Unable to Communicate with Drive on SCSI Port X, Drive ID Y .............................................

Unable to Retrieve Identify Controller Data. Controller May be Disabled or Failed.................

Unknown Disable Code..............................................................................................................

Unrecoverable Read Error ..........................................................................................................

Warning Bit Detected .................................................................................................................

WARNING - Drive Write Cache is Enabled on X.....................................................................

WARNING: Storage Enclosure on SCSI Bus X Indicated it is Operating in Single Ended 
Mode...........................................................................................................................................

Write Memory Error...................................................................................................................

Wrong Accelerator .....................................................................................................................

 

This section contains a complete alphabetical list of all ADU ("Array Diagnostic 
Utility" on page 

) error messages. 

IMPORTANT:  This guide provides information for multiple servers. 
Some information may not apply to the server you are troubleshooting. 
Refer to the server documentation for information on procedures, 
hardware options, software tools, and operating systems supported by 
the server. 

  WARNING:  To avoid potential problems, ALWAYS read 

 

 

Description: Array controller did not detect a configured array accelerator board. 

Action: Install an array accelerator board on an array controller. If an array 
accelerator board is installed, check for proper seating on the array controller 
board.