Source Technologies SECURE MICR PRINTER ST9630 Manual Do Utilizador
Source Technologies, LLC ST9630 Secure MICR Printer User’s Guide
34
MICR Type designates the printer as a “normal” Source Technologies secure MICR
printer. The default is “normal.” Hex Transfer and Density Control are normally reserved
for ST Technical Support.
MICRpoint is a feature that allows for fine positioning of the MICR line by the operator.
The Audit Menu deals with the optional Audit Trail Report settings. See chapter 7 for
more information.
printer. The default is “normal.” Hex Transfer and Density Control are normally reserved
for ST Technical Support.
MICRpoint is a feature that allows for fine positioning of the MICR line by the operator.
The Audit Menu deals with the optional Audit Trail Report settings. See chapter 7 for
more information.
Entering MICR Mode
To print MICR documents, your Secure MICR Printer uses special alphanumeric text
commands called MICR Mode commands.
There are two different commands which activate MICR mode printing:
&%STFPASSWORD$ and &%STHPASSWORD$. &%STF is the default command and
is recommended for most applications.
To use the &%STF command, it must be entered at the beginning of the job datastream.
The &%STH command can be entered anywhere prior to accessing secured resources.
The &%STH command is not as powerful as the &%STF command because it does not
set as many parameters for MICR printing. Both commands and descriptions are as
follows:
commands called MICR Mode commands.
There are two different commands which activate MICR mode printing:
&%STFPASSWORD$ and &%STHPASSWORD$. &%STF is the default command and
is recommended for most applications.
To use the &%STF command, it must be entered at the beginning of the job datastream.
The &%STH command can be entered anywhere prior to accessing secured resources.
The &%STH command is not as powerful as the &%STF command because it does not
set as many parameters for MICR printing. Both commands and descriptions are as
follows:
&%STF Command
When entering MICR mode with the &%STF mode, the printer will:
When entering MICR mode with the &%STF mode, the printer will:
•
Check to see if the proper Front Panel Combination has been entered
(when enabled).
•
Allow access to secure check printing resources such as MICR fonts and
secure fonts stored in printer ROM.
•
Allow access to protected signatures, overlays, logos and other important
resources stored in password protected nonvolatile flash memory.
•
Display “MICR Mode Active” on the printer’s front panel.
•
Disable the printer’s front panel menu system.
•
Set printer resolution to 600 dpi for printing MICR fonts.
•
Disable Jam Recovery.
•
Set the copies parameter to 1.
•
Sets Toner Low Alarm.
•
Turn Hex Transfer ON.
Note:
The &%STF command must be entered at the beginning of the print
job before any other print data is received.
&%STH Command
The &%STH command does not set-up the printer for check printing activity as
completely as the &%STF command mode. This alternate MICR mode command
forces the user to manually program some commands through their host
application. It is used when programmers cannot place &%STFPASSWORD$ at
&%STH Command
The &%STH command does not set-up the printer for check printing activity as
completely as the &%STF command mode. This alternate MICR mode command
forces the user to manually program some commands through their host
application. It is used when programmers cannot place &%STFPASSWORD$ at
MICR Features | 6