Yamaha PJP-50R Manual Do Utilizador

Preparation Procedure

Set up the system according to the network or telephone circuit to which the system is connected.

Communication through the Internet or LAN

The setup items are variable depending on whether or not the DHCP server is used.

When using the DHCP server:
See “LAN: Acquiring the network information from a DHCP server” (page 6).

When not using the DHCP server:
See “LAN: Setting the network information manually” (page 6).

Communication through the public switched telephone circuit

See “Telephone circuit: Setting the telephone circuit type” (page 10).

■ LAN: Acquiring the network information

from a DHCP server

When this unit is used in a network containing a DHCP
server, no setting operation is required since the DHCP
server assigns all of the necessary network information
automatically.

To check if the correct network information
is obtained

Make sure that “Tel & IP ready” or “IP ready” is displayed
as shown below.

If “IP ready” or “Tel & IP ready” is not displayed or
“???.???.???.???” is displayed, the network information has not
been ontained correctly.

■ LAN: Setting the network information

manually

Follow the procedure below to register the network
information manually.

Before setting the network information, check that this unit is
connected properly to the network. If the LED of the LAN port is
not lit, this system is not connected properly to the network.

The factory settings of the network information are as follows.

–

IP address: 192.168.100.200

–

Subnet mask: 255.255.255.0

–

Default gateway: 0.0.0.0

–

DNS server: 0.0.0.0

Step 2: Registering the settings of this unit

(192.168.100.200)

:Address

2007.09.20 12:16:14

Tel & IP ready

Note

MIC MUTE

HOOK

/STANDBY

VOL

Numeric keys