ZyXEL NSA-2400 Manual Do Utilizador
NSA-2400 Quick Start Guide
3
2 Pull out the latch and grip the sides of the
tray to remove disk tray 1. Be careful not
to break the latch. Disk bay 1 is labelled on
your NSA (the top-left bay).
to break the latch. Disk bay 1 is labelled on
your NSA (the top-left bay).
3 Place the disk tray on a flat surface with
the panel facing up. Place a hard disk with
the screw holes facing up on the same
surface and slide it into the disk tray.
Secure it with the screws as shown.
the screw holes facing up on the same
surface and slide it into the disk tray.
Secure it with the screws as shown.
4 Push the top of the tray back into NSA disk
bay 1 until it snaps into place and push the
latch up as shown.
latch up as shown.
5 Repeat steps 1 to 3 for other hard drives
that you may have.
2 Make the NSA
Connections
Connections
1 Connect the Ethernet port on the rear of the NSA to a hub, switch, or
router on your network using an Ethernet cable. Use an 8-wire Ethernet
cable for Gigabit connections.
cable for Gigabit connections.