Zhone IMACS-200 Manual Do Utilizador
FXS Ports
6-9
TO NTWK
In cross-connect systems only, the To Network parameter allows you to break the circuit and
send a test tone on the network side of the system. The options for this field are none, and
D-mW. Choose none if you do not want to inject a tone toward the network. In this case, the
PCM signal received from the CPE is still sent to the network in the normal manner.
send a test tone on the network side of the system. The options for this field are none, and
D-mW. Choose none if you do not want to inject a tone toward the network. In this case, the
PCM signal received from the CPE is still sent to the network in the normal manner.
Tx ABCD
The Transmit ABCD informational field shows the current values of the ABCD bits that are
being transmitted to the network. If TX ABCD in the top half of the screen is changed via the
set function mentioned above, and the settings are saved by the Save command in the Menu
of Actions, the new bit pattern chosen will be reflected here.
being transmitted to the network. If TX ABCD in the top half of the screen is changed via the
set function mentioned above, and the settings are saved by the Save command in the Menu
of Actions, the new bit pattern chosen will be reflected here.
Rx ABCD
The Receive ABCD informational field shows the current values of the ABCD signaling bits
that are received from the network. If RX ABCD in the top half of the screen is changed via
the set function mentioned above, and the settings are saved by the Save command in the
Menu of Actions, the new bit pattern chosen will be reflected here.
that are received from the network. If RX ABCD in the top half of the screen is changed via
the set function mentioned above, and the settings are saved by the Save command in the
Menu of Actions, the new bit pattern chosen will be reflected here.
MODE
The Mode informational field shows the current mode of the port that was selected on the main
FXS port Screen. Valid settings are fxs.
FXS port Screen. Valid settings are fxs.
TYPE
The Type informational field shows the current status of the signal field selected on the main
FXS port screen for this port. Valid settings for fxs and wink modes is loop (loop start).
FXS port screen for this port. Valid settings for fxs and wink modes is loop (loop start).
STATUS
The Status field shows the current status of the port. Table 6-5 lists and describes all of the
possible conditions reported by this field.
possible conditions reported by this field.
Table 6-5. Status Information Field Settings
Setting
Meaning
stdby
The FXS port is in standby.
W stb
WAN port to which the FXS port is assigned is in standby.
W tst
WAN port to which the FXS port is assigned is under test.
W OOS
WAN port to which the FXS port is assigned is out of service.