Voodoo Lab PEDAL POWER 2 Manual Do Utilizador

On the bottom of the Pedal Power is an 8 position DIP switch with
switches numbered 1-8. These switches correspond to Outputs 1-8
and select the output voltage. Normally, they should all be in the
“OFF” or “NORMAL” position for 9 volt operation.

There are two types of Boss pedals. These are identified by the type
of power supply specified, either PSA or ACA. Almost all Boss
pedals specify the PSA type adapter and operate at 9V like most
other pedals. Boss pedals which specify the ACA type adapter
operate at a higher voltage. When powering Boss pedals that require
ACA adapters you must use outputs 1-4 only and switch the corre-
sponding Voltage Selector DIP Switch on the Voodoo Lab Pedal
Power to the “ON” position.

For example, let’s say you have a Boss CS-3 Compressor/Sustainer.
Next to the power jack is a sticker which says “Use BOSS ACA
adapter only”. You are connecting a barrel connector cable from
Pedal Power DC Output #3 to the CS-3 power jack. Since the CS-3
specifies an ACA type adapter, you must set Voltage Selector DIP
Switch #3 on the bottom of the Pedal Power to the “ON” position.

You can power the Line6 modeling pedals (but not the POD) using
outputs 5 or 6 and setting the corresponding switch to the “ON”
position. Remember to use the RED 5.5x2.5mm barrel cable for
these pedals.

Outputs 7 and 8 permit you to adjust or SAG the voltage from about
4V to 9V. To enable this feature you must set the corresponding
switch to the “ON” position. This allows you to simulate worn bat-