Vogue Industrial ABOVE GROUND SWIMMING POOL Manual Do Utilizador

Diagonal

Diagonal

Pool

Wall

Front edge

of ‘T’ Brace

9cm

9cm

6cm

Ground Level

Top of Concrete Pad should

be no higher than ground level

3

If you have purchased an oval shaped pool, you will find in the installation manual that you will have to form a concrete
pads to support ‘T’ support braces. The braces are located along the straight side of the pool only. 

As an alternative to forming an individual concrete base under each ‘T’ support, we recommend that you pour just one
concrete pad to support all of the braces - please see diagrams below. 

The concrete pad MUST be able to receive the ‘T’ Support Braces, to do this you will have to form 
8cm x 8.5cm slots in a 14cm depth concrete pad(s). We have allowed for a small tolerance in our measurements  to allow
for adjustment compared to the Vogue Installation Manual.
To help you form the slots in the concrete pad we have provided Polystyrene blocks to
enable you to form the correct size slots when pouring the concrete. USE A
6:1 

(6 X BALLAST- 1 X CEMENT)

CONCRETE MIX - FAIRLY DRY, TOO

MUCH WATER AND THE POLYSTYRENE WILL FLOAT!
Make sure that all visible turf is removed and the ground where
you intend to install the pool is level, this is paramount to
ensuring that you have a trouble free installation. 

Check the diagonals are correct and that both pads are
installed level. The finished concrete pad should be level  with
the surrounding ground.

Make sure the

ground is level!