Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006 Manual Do Utilizador

4

Use the supplied hose union to attach the
supplied 5/8" hose to the engine breather
hose that was disconnected from the factory
air-inlet duct.

Attach the MAF to the supplied duct using the
supplied 6mm hardware. The bend in the duct
should point the same way as the plug on the
MAF. Ensure the MAF O-ring is present.

Using the supplied 3" tube and sleeves,
attach the MAF to the throttle body. Plug in
the MAF electrical connector.

Install a 2.75" to 2.5" reducer onto the end of
the duct. (See Fig. 4-a.)

Install the cast intermediate duct into the
vehicle  (see Fig. 4-b) and then slide it up into
the reducer sleeve. The duct should be routed
between the flexible A/C line and the frame
with the bent end pointed down. (See Fig.
4-c.)

Install and tighten clamps on each connec-
tion. (These may need to be loosened after
the supercharger is installed to improve the
fit.)

BEND A/C LINE TO PROVIDE

DUCT CLEARANCE AS NEEDED