Xpress DBALL Manual Do Utilizador
Rev.: 20120307
Platform: DBALL
Firmware:
Firmware:
CHRYSLER Remote Start Ready Installation
© 2012 Directed. All rights reserved.
1
6
10
DBALL
RF
Programming button
LED
4
14
12
2
2: Violet/Yellow: J1850
8: Yellow
9: Orange/Yellow
Module-Sentry Key
Remote Entry
V
iolet/Brown,
Pin
2
1
Connector
side view
(+)
Start,
Pin
4
(+)
Ignition,
Pin
3
J1850
Sentry Key
(+) Ignition
8: Violet/Green: Multiplex Output
9: Violet/Brown: Multiplex Output
14: Black: (-) Ground
(-) Ground
13: Red: (+) 12v
(+) 12v
Installation Type 5 (without T-Harness)
Page 16
Important!
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
The Hood Pin and Neutral Safety Switch are mandatory security devices, but are NOT supplied with the DBALL.
TX
(-) Ground
RX
(+) 12v
The
XL202 and antenna are not included and MUST be
purchased separately.
optional
LED
OR
Programming
Button
4
4
XL202
Antenna
(+)12v
TX
(-) Ground
(-) Ground
RX
SmartStart is
not included. It MUST be purchased
separately.
optional and
You can either connect to an XL202 module
or to a SmartStart module.
or to a SmartStart module.
LED
SmartStart
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins
(+)12v
TX
(-) Ground
RX
Wires are listed by pin numbers. This display is not representative of connector pin layouts, which are often stacked.
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
7: Gray/Black: (+) Ignition
11: Yellow/Red: (+) Start
Parking Lights
See page 17 for
wiring information
2: Green/Black: (-) Parking Lights
12: Brown/Red: (+) 12v
(+) 12v
XOVER
CABLE