Symantec NETBACKUP 7 Manual Do Utilizador
4
Save and close the file.
5
Restart the NetBackup Remote Manager and Monitor Service (
nbrmms
) on the
host.
pd.conf file settings
describes the deduplication settings that you can configure.
Table 5-4
pd.conf file values
Action
Possible values
Default value
Setting
Writes the log information to the specified file.
Uncomment the DEBUGLOG line that corresponds
to your operating system and then specify the
log file path. You can specify a different location
and log file name.
log file path. You can specify a different location
and log file name.
Any path
C:\pdplugin.log
(Windows)
tmp/pdplugin.log
(UNIX)
DEBUGLOG
Specifies the amount of information that is
written to the log file. The range is from 0 to 10,
with 10 being the most logging.
written to the log file. The range is from 0 to 10,
with 10 being the most logging.
Note:
Do not change this setting unless directed
to by a Symantec Technical Support
representative.
representative.
0
through 10
0
LOGLEVEL
Specifies whether you want compression. By
default, files are not compressed. If you want
compression, change the value to 1.
default, files are not compressed. If you want
compression, change the value to 1.
See
on page 28.
0
(off) or 1 (on)
0
COMPRESSION
Specifies whether you want encryption. By
default files are not encrypted. If you want
encryption, change the value to 1.
default files are not encrypted. If you want
encryption, change the value to 1.
See
on page 28.
0
(off) or 1 (on)
0
ENCRYPTION
This keyword is reserved for internal use.
Note:
Do not change this setting unless directed
to by a Symantec Technical Support
representative.
representative.
PREFETCH
61
Configuring deduplication
Editing the deduplication configuration file