Strong Enterprises SRT 60 Manual Do Utilizador

n 

Press YELLOW “SUB” button to switch on subtitle support.

n 

Press EXIT to leave the subtitle function.

You can read the current program information if you press the INFO button (or OK button twice) on the 
remote control.

n 

Press RED button for EPG Details of the running program. The info will disappear after 5 sec. 
or after pressing INFO button again.

n 

Press GREEN button to show detailed signal information. The info will disappear after 5 sec. 
or pressing EXIT button.

Press INFO (or OK button twice) and then the YELLOW button to enter the submenu where you can edit 
the channel name. Keypad Dialog will appear. Enter the new name and press OK to confirm.

Press TV/AV button on your remote control to switch between receiver and TV set.
Note:  When receiver is in standby mode (turned off), TV/AV button will not be active. In standby mode it 

will automatically change to TV set.

Press TV/RADIO button on your remote control to switch between TV and radio channels.

In some region, the digital terrestrial signal may be weak. So you’d better use the antenna in which the 
booster was built, for watching the weak signal channels.

Standby light not lit on 
IR-eye

-Power supply unplugged
-
- IR-Eye not well connected or 
defective

-Connect Power supply 

-Check connection of IR-Eye or try 
another one

No signal found

-Antenna is disconnected

-Antenna is damaged/misaligned

- Out of digital signal area

- Check aerial lead

- Check aerial

- Check with dealer/installer of the SAT 
System or call the Support Hotline