Sierra 200 Manual Do Utilizador

  

70 

C404 (u)  Set remote base radio frequency in Hz 

 

 

Syntax is C404rffffffffff, where r is the logical port number and 
ffffffffff

 is the absolute frequency in Hz.  The maximum value is 2^32 

Hz, or a little over 4 GHz.  For radios capable of higher frequencies, the 
frequency entered is interepreted as 10's of Hz. 

 

C405 (u)  Set remote base radio frequency last digit of MHz and kHz 

 

 

Syntax is C405rfffff, where r is the logical port number and fffff is the 
frequency offset from the last set frequency value truncated to the nearest 10 
MHz.   

 

For example, C402146D sets the frequency to 146 MHz.  However, the C405 
value will be added to 140 MHz.  A subsequent C40526520D sets the 
frequency to 146.52 MHz. 

 

C406 (u)  Set remote base radio frequency interactively 

Not yet implemented 

 

C407 (u)  Set remote base radio repeat mode 

 

 

Syntax is C407rnnn, where r is the logical port number, and nnn designates 
the repeat mode, as follows: 

 

C408 (u)  Set remote base radio repeat offset 

 

 

Syntax is C408rnnnnnn, where r is the logical port number, and nnnnn is 
the odd repeat split offset, in kHz.  Plus or minus is indicated by the set repeat 
mode command. 

 

C409 (u)  Set remote base radio repeat reverse 

 

 

Syntax is C409r, where r is the logical port number.   

 

This command swaps transmit and receive from the normal setting (the 
previous set frequency value is the transmit frequency instead of the receive 
frequency).  The state of this mode after entering any of the set frequency 
commands is radio type dependent.  

 

NOT YET IMPLEMENTED