Siemens Webcam TP177B Manual Do Utilizador
Automation and Drives - SCE
T I A Training Document
Page 37 of 129
Module
F6
Issued: 02/2008
Operator Control with WinCC flexible 2005
Preface Installation Project Description Step7 Project HMI Station WinCC flexible Project Messages Recipes User Management
5.3
Checking the Connection with NetPro
Start NetPro by clicking on the button in the SIMATIC Manager.
Here, you can check the communication connections very easily.
Also, you can make changes or corrections subsequently with NetPro.
With a double click, the module’s properties are opened.
IMPORTANT NOTE
NetPro, the hardware configuration, and WinCC flexible access a joint data base and must not be
opened at the same time.
If one of these programs is opened, only reading functions are often possible in the next program.
The advantage is that a change of the MPI address, for example, is accepted in all programs.