Siemens IGWIPS200-1 Manual Do Utilizador
IGWiPS200-1
MOUNTING THE DIN RAIL
At each installation site, mount the DIN rail and DIN rail mount modules (e.g. transceiver, I/O modules, power
supply) in a NEMA enclosure appropriate for the environment and hazardous area classification. Refer to Figure 3
for transceiver and I/O module dimensions. Allow room for:
At each installation site, mount the DIN rail and DIN rail mount modules (e.g. transceiver, I/O modules, power
supply) in a NEMA enclosure appropriate for the environment and hazardous area classification. Refer to Figure 3
for transceiver and I/O module dimensions. Allow room for:
o
Physically mounting and wiring the modules and for antenna, power, ground and signal wire runs
o
Accessories (e.g. low loss cable and MCX to N-type connector adapter, surge voltage protection adapter)
o
Conduit adapters
o
Operator controls
o
Circuit protection/safety devices (e.g. switches, circuit breakers, or fuses)
o
Other items as determined by the installer/user.
Fasten the DIN rail to a rigid panel within the enclosure using user-supplied hardware. An enclosure is required in a
hazardous area installation. In a non-hazardous area, a secure enclosure can provide safety for area personnel and it
restricts access to the equipment.
IMPORTANT
The DIN rail must be grounded. When mounting the DIN rail in a non-conductive
enclosure, install a ground wire between the rail and the single point ground.
enclosure, install a ground wire between the rail and the single point ground.
DIN Rail Mount Transceiver or I/O Expansion Module
Figure 3 Physical Dimensions
MOUNTING A TRANSCEIVER OR I/O MODULE
I/O Expansion Modules may be mounted on a section of DIN rail in any sequence. Mount the Transceiver at either
end of the row of up to 8 I/O modules, to ensure sufficient heat dissipation.
I/O Expansion Modules may be mounted on a section of DIN rail in any sequence. Mount the Transceiver at either
end of the row of up to 8 I/O modules, to ensure sufficient heat dissipation.
IMPORTANT
If a module contains configuration switches that have not been set, refer to I/O Module
Configuration Switch Selections on page 11 before installing the module on DIN rail. A list
of modules with configuration switches is provided in the referenced section.
Configuration Switch Selections on page 11 before installing the module on DIN rail. A list
of modules with configuration switches is provided in the referenced section.
At each installation site, the transceiver and I/O modules are interconnected by built-in bus connectors; see Figure 4
below. Each module has male bus connectors on one side and female bus connectors on the other. When mounting
modules on a DIN rail, be sure to correctly orient modules so they interconnect and the module faceplates are
oriented for easy reading. Refer to the following procedures to install modules.
May 2007
14