Sanyo ECD-T1560 Manual Do Utilizador

Press LOC/S-MOD button (5) to switch Category mode, Skip mode or normal. It is used as the 
selection of each: 
             Normal      Category mode     Direct Tune     Skip Channel mode       
                             

   

When Category mode or Skip mode is engaged, the “CATEGORY” or “SKIP” function is turned 
on in the display. When Category mode or Skip mode is released, the “CATEGORY” or “SKIP” 
function is turned off. When Direct mode is engaged, “DIRECT” of alphanumeric display is turned 
on. 

Use CAT/DIR

 

button (7) or CAT/DIR

   

button (6) to select desire Category and press 

BAND/LOUD/ENT button (2). 
In Category mode, stations can be tuned within the same category. 
- 

When the user wishes to search by Category, press LOC/S-MOD button (5) can be pressed 
until it goes into Category search mode. 

- Press 

   

button (7) or CAT/DIR

   

button (6) up and down to get to the desired 

category. 

- 

To change channels, press LOC/S-MOD button (5) again to Normal mode, and then press 
MANU/SKIP/CH 

 

or 

  button (3) to select the channel up or down. 

In Skip mode, pressing LOC/S-MOD button (5) for more than 3 seconds sets the SKIP channel 
mode. Details for set or release skip channel is as follows. 
Use MANU/SKIP/CH 

 

or 

  button (3) to be switched to SKIP channel set or release 

mode sequentially. 
- Press 

BAND/LOUD/ENT button (2) to select skip or release the following channel. (If the 

channel was skipped, the “SKIP” icon will be displayed. 

- Press 

LOC/S-MOD button (5) for more than 3 seconds again to return to basic mode 

automatically after 10 seconds. 

Note:   
  In skip mode, use MANU/SKIP/CH 

 

or 

  button (3) to show skipped channels.

1.  In direct mode, display shows DIRECT and “000” channel number. (Hundred Digit flashing 

on/off) 

2. Use 

 

or 

  button (3) to select hundred digit. 

3. Press 

LOC/S-MOD button (5) again to confirm entry of the hundred digit and the 10s digit is 

flashing on/off. 

4. Use 

 

or 

  button (3) to select 10s digit. 

5. Press 

LOC/S-MOD button (5) again to confirm entry of the 10s digit and the 1s digit is 

flashing on/off. 

6. Press 

LOC/S-MOD button (5) again to confirm entry of the 1s digit. 

7. Press 

BAND/LOUD/ENT button (2) to direct tune. 

 

 

 

 

3