Saab Automobile Accessories G3 Manual Do Utilizador

The motherboard in the I/O Box contains a power supply, a
communication watch dog with System Failure output,
seven relay outputs and seven slots for plug in of various
Interface Boards. The seven serial channels are directly wired
to the seven connectors for the Interface Boards.

There is a red LED (H4) on the motherboard indicating that
there has been an interruption of the communication with
the Work Station. The LED remains lit after the watch dog
has been triggered. This LED will normally be lit since this
watch dog will trigger while the Work Station is starting up

after a black-out or after the Work Station has been switched
on. When there is an interruption of the communication to
the Work Station, watch dog is triggered and the watch dog
LED lights up and remains lit.

Check function of I/O Box by following the steps below.

1.

Open cover of I/O Box.

2.

Locate the red watch dog LED and a reset switch right
next to it on the motherboard of the I/O Box.

3.

Beside it there is a reset switch.

4.

Make sure the Work Station (if more than one Work
Station – the master Work Station) is running.

5.

Press the reset switch in the I/O Box.

6.

Wait for approximately half a minute. The watch dog
LED should not light up.

X30

X31

X8

X37

H3

H2

H4

H10

RST

X1

H11

X2

H12

X3

H13

X4

H14

X5

H15

X6

H16

X7

H17

Voltage
selector

F3

F4

X10

X11

X12

X13

X14

X15

X16

X17

X9